Unable to configure GigabitEthernet 0/0 Internet access
I have tried to configure my Cisco 2911 ISR router to allow client computers from accessing Internet but it seems something is missing. The client PCs were able to receive IP parameters from the DHCP i...
View ArticleUnable to configure GigabitEthernet 0/0 for connecting to Internet
NAT/PAT Translations?
View ArticleUnable to configure GigabitEthernet 0/0 for connecting to Internet
default route? you are going to need to post your config (scrub outside IPs and username info)
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
My config as follows:hostname adminenable password ******lin con 0password ******loginline vty 0 5password ******logininterface GE 0/1ip nat insideip address 192.168.0.254 255.255.255.0no...
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
i dont think you want to NAT the traffic on the inside. get rid of the ip nat inside on int G0/1 and change the interface for the NAT statement to the outside interface- "ip nat inside source list 102...
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
Can you view how I created and applied the ACL, is anything seems to be wrong?
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
ACL looks fine. it is just saying that anyone from your 192 subnet can use NAT. it is just applied to the wrong interface
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
I can ping all configured EigabitEthernet ports on the router, i can obtain ip parameters from the DHCP I configured on the router. The problem is that i can not get to the Internet via the router. I...
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
192.168.0.0/24 is a connected network so you don't need the static route.
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
lets see the output of sho int g0/0
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
Phil Denton wrote:192.168.0.0/24 is a connected network so you don't need the static route.Seconded.Also I'd remove the access-list entry from the Gig 0/0 interface. I know what you're trying to...
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
Your original config was correct - but as TCOB indicated you were natting to the wrong interface. Should be:ip nat inside source list 102 interface GigabitEthernet0/0 overloadstatic routes are...
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
Thanks to you all especially TCOB, m@ttshaw, mark9586 for your help so far. I have sorted it out and everything is working. I changed the interface where i applied the ACL and it didn't work until I...
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
it basically enables routing. you would think that it would be on by default but it is not. without it you can not route (leave your vlan).
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
It's usually on by default on an IOS router, and off by default on Layer 3 switches. The only time I have had to enable IP routing on a router is when it has been disabled deliberately, which is common...
View ArticleUnable to configure GigabitEthernet 0/0 Internet access
Hi everyone,Could you tell why the DHCP on the Cisco router 2911 I struggled to bring up sometimes stops assigning IP Addresses? When it happens, I normally configure it again but now it stops working....
View Article
More Pages to Explore .....